Torna al blog
Guide pratiche 2026-11-20 AllPetSolutions 0 visualizzazioni

AP-6 Aquarium Air Pump Setup Guide

AP-6 Aquarium Air Pump Setup Guide

Learn how to set up the 336L/H AP-6 air pump kit with two outlets, air stones, and non-return valves for quiet, reliable aquarium aeration.

What the AP-6 Kit Includes

The AllPondSolutions AP-6 aquarium air pump complete kit delivers 336L/H through two independent outlets, making it easy to run multiple air-driven accessories from a single pump. The kit comes with two free air stones (48mm long, 18mm diameter) and two 2-meter lengths of 6mm air hose, plus two non-return valves. This saves both sockets and shelf space compared to using separate pumps.

Setting Up the AP-6 Air Pump

Follow these steps to get your AP-6 running quietly and reliably.

  1. Position the pump above water level: Place the AP-6 unit higher than the top of your aquarium. This prevents water from flowing backwards into the pump if the power cuts. Alternatively, you can fit the supplied non-return valves on each outlet line.
  2. Attach the air hose and non-return valve: Cut the 6mm air hose to your desired length. Connect one end to a pump outlet, then attach a non-return valve in line (the arrow on the valve should point away from the pump). The valve allows air out but stops water siphoning back.
  3. Connect the air stone: Push the free end of the hose onto the barb of the 48mm air stone. Place the stone at the bottom of your tank, or wherever you want fine bubbles. For protein skimmers using ceramic stones, check the skimmer's inlet size.
  4. Adjust the flow: Use the built-in flow controller on the pump to dial in the desired bubble rate. Start low and increase until you get the aeration you need without excessive splashing.
  5. Plug in and test: Plug the pump into a mains socket. Check that bubbles are coming from both air stones and that no water is creeping back up the hose. If you see water in the hose, reposition the pump higher or check the non-return valve direction.

AP-6 Kit Specifications

  • 336L/H Aquarium Air Pump Complete Kit AP-6: The AP-6 pump delivers 336L/H through two outlets and includes two 48mm air stones, two 2m lengths of 6mm air hose, and two non-return valves. These components give you everything needed for a complete setup out of the box, with enough hose length to reach most tank placements.
    336L/H Aquarium Air Pump Complete Kit AP-6
    336L/H Aquarium Air Pump Complete Kit AP-6

Placement and Noise Tips

The AP-6 is designed for long life and low-frequency operation, running quietly with little vibration. To keep noise to a minimum, place the pump on a soft surface (like a foam pad or cloth) rather than directly on a hard shelf. Ensure the unit is above water level to prevent back-siphoning, as noted in the supplied instructions.

Using Both Outlets Effectively

With two outlets, you can run an under-gravel filter on one line and an air stone on the other, or feed a box filter and a protein skimmer simultaneously. The flow controller lets you balance the output between the two lines. If you only need one accessory, cap the unused outlet or fit a T-piece for a single larger stone.

Articoli correlati

Customer Service
Home
Prodotti
Carrello
Profilo