How to Set Up a Nano Curve Acrylic Fish Tank

Quick answer

Set up your Nano Curve Acrylic Fish Tank by placing it on a level surface, adding substrate and water, then installing the integrated filter and light—no plumbing required.

Setup steps for your Nano Curve Acrylic Fish Tank

1. Choose and level the location: Place the tank on a flat, stable surface that can support at least 15 kg. The curved front viewing area works best at eye level on a desk or low shelf. A slight tilt can stress the acrylic seam. Use a spirit level if you are unsure.
2. Add substrate and decorations: Rinse aquarium gravel or sand thoroughly before adding a 2-3 cm layer. Arrange hardscape and plants, leaving space around the internal filter intake. Do not push substrate against the filter intake—it can block the pump and cause overheating.
3. Fill with water: Pour dechlorinated water slowly onto a plate or your hand to avoid disturbing the substrate. Fill to about 2 cm below the rim. Tap water contains chlorine that kills beneficial bacteria. Always use a water conditioner.
4. Install the integrated filter and light: The 2w filter pump and 4w LED light clip into the recess at the back of the tank. Plug them in and check that water flows evenly from the outlet. If the pump runs dry for more than a few seconds, it can seize. Ensure water covers the pump body before switching on.
5. Cycle the tank before adding fish: Run the filter for 4-6 weeks with a small ammonia source (fish food or pure ammonia) to grow beneficial bacteria. Test water weekly until ammonia and nitrite read zero. Adding fish immediately is the most common cause of death in new tanks. Patience pays off.

Product facts

• Nano Curve Acrylic Fish tank 13.5L: The AllPondSolutions 13.5 litre Nano Curve carries its 4w light and 2w filter pump inside the body of the tank, so setting up means filling it and switching it on. You don't need to buy or plumb separate external equipment, making this one of the simplest all-in-one small aquarium setups available.