Why a Multi-Outlet Air Pump Simplifies Your Tank Setup
If you run an under-gravel filter, a box filter, air stones, and a protein skimmer, you don't need a separate pump for each device. The AllPondSolutions AP-12 air pump delivers 672L/H through four outlets, letting you feed four air-driven items from one unit. This guide walks through the setup steps using the components included in the complete kit.
What's in the Box
- 672L/H Aquarium Air Pump Complete Kit AP-12: Four outlets on one pump means four air-driven items fed at once, without a row of separate units cluttering the cabinet. You can connect up to four devices (e.g., two air stones, one under-gravel filter, one protein skimmer) without buying additional splitters or pumps.

672L/H Aquarium Air Pump Complete Kit AP-12 - 672L/H Aquarium Air Pump Complete Kit AP-12: 4 x Free air stones (48mm (L) x 18mm (D)) The kit includes four medium-sized air stones, so you can start aerating right away without a separate purchase.
- 672L/H Aquarium Air Pump Complete Kit AP-12: 4 x Free air hoses (6mm) x 2m Each outlet comes with its own 2-meter hose, enough to reach most tank positions without needing extra tubing.
- 672L/H Aquarium Air Pump Complete Kit AP-12: 4 x Free non-return valves. These prevent water from siphoning back into the pump if it's placed below the water line, protecting the pump from damage.
Step-by-Step Setup
- Choose a location above the water level: The manufacturer recommends locating the unit above water level to prevent water flowing backwards. If you must place it lower, fit one of the supplied non-return valves on each hose.
- Attach the non-return valves: Push a non-return valve onto the end of each 2m hose. The valve should be oriented so that air flows toward the tank (the arrow on the valve body indicates direction).
- Connect hoses to the pump outlets: The AP-12 has four outlet ports. Slide one hose (with valve attached) onto each outlet. No tools are needed — the 6mm hose fits snugly.
- Place air stones or devices: Attach the free air stones to the other end of each hose. For under-gravel filters or box filters, connect the hose directly to the filter inlet instead.
- Position the air stones in the tank: Submerge the air stones or filter intakes in the aquarium. Ensure the hoses are not kinked and that the pump remains dry and stable.
- Plug in and adjust flow: The pump features a flow controller on the unit. Turn it to your desired output. The pump is designed for low noise and low vibration during continuous use.
Tips for Using All Four Outlets
Because each outlet has its own hose and valve, you can run different types of devices simultaneously. For example, use two outlets for air stones in opposite corners of the tank, one for an under-gravel filter, and one for a box filter. The 672L/H total output is split across the four lines, so each gets roughly 168L/H — enough for typical aeration tasks.
If you only need two or three outlets, you can cap the unused ports with a short piece of hose and a valve, or simply leave them open (the pump will still push air out, but it's quieter to cap them).
Maintenance and Long-Term Use
The AP-12 is built for continuous operation, but a few simple checks keep it running smoothly. Clean or replace the air stones every few months if they clog with algae or mineral deposits. Inspect the non-return valves periodically to ensure they still seal properly — a stuck valve can allow water to creep back toward the pump. Keep the pump itself dry and dust-free, and check that the air intake on the unit is not blocked.


